Model #750 Working Requirements

 * * * STRAIGHT LIFT USE ONLY * * *

DO NOT

· DRAG
· PULL
· PUSH

Lock-N-Lift Tools are not to be used for side pull or push.  If the tools are dragged or pushed to the side or along the ground while in a steel trench plate, stress will develop on the ankle part of the tool causing foot breakage and/or the center plate to become pinched.  If a tool is abused in this fashion, tool life will be shortened and the working load limit for the tool will be unknown.

The Model 750 Tool is designed to be used with a shackle only and must be inserted into a Lock-N-Lift #500B weld plate. It may be used with a chain or anchor shackle. 

Large Plates

For extra long plates, it is recommended that two tools be used with a spreader bar for stability and to minimize stress.  The plate should be measured in thirds along its longest part and a #500B weld in plate placed on each third division.

Shackle Recommendations

The Model 750 tool works well with either anchor or chain shackles with either 7/8” or 1” diameter pins.  The shackles should have a working load limit of 4 tons minimum.

Specifications

Dimensions: 3” L X 2-1/4” W X 4” HWeight:3.75 Pounds
Material: AISI 4330 Chrome-Moly SteelHeat Treatment: Normalize, Quench & Temper
Safe Working Load: 8,000 poundsSafety Factor: 5:1 minimum

Test Results

A copy of certified test results for the Model 750 tool are available on request.  The tested breakout capacity for this tool is 60,000 pounds minimum.

Again, Lock-N-Lift Tools are to be used for STRAIGHT LIFT ONLY.